Accessories And Replacement Parts - Vega VEGABAR 52 Operating Instructions Manual

3 Product description
Transport
Transport inspection
Storage
Storage and transport
temperature
Indicating and adjust-
ment module
Interface adapter
External indicating and
adjustment unit
10
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. For special versions, PE foam or PE foil
is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out under consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or
concealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
Not in the open
l
Dry and dust free
l
Not exposed to corrosive media
l
Protected against solar radiation
l
Avoiding mechanical shock and vibration
l
Storage and transport temperature see chapter "Supplement -
l
Technical data - Ambient conditions"
Relative humidity 20 ... 85 %
l

3.5 Accessories and replacement parts

The indicating and adjustment module PLICSCOM is used for
measured value indication, adjustment and diagnosis. It can be
inserted into the sensor and removed at any time.
You can find further information in the operating instructions "Indicating
and adjustment module PLICSCOM" (Document-ID 27835).
The interface adapter VEGACONNECT 4 enables the connection of
communication-capable instruments to the USB interface of a PC. For
parameter adjustment of these instruments, an adjustment software
such as PACTware with VEGA-DTM is required.
You can find further information in the operating instructions "Interface
adapter VEGACONNECT" (Document-ID 32628).
VEGADIS 61 is suitable for external measured value indication and
adjustment of plics® sensors. It is connected to the sensor with an up
to 25 m long, four-wire, screened standard cable.
You can find further information in the operating instructions
"VEGADIS 61" (Document-ID 27720).
VEGABAR 52 • 4 ... 20 mA/HART