Vega VEGABAR 52 Operating Instructions Manual page 19

VEGABAR 52 • 4 ... 20 mA/HART
Remove the housing socket from the mounting plate
2
1
2
Fig. 8: Components of the external housing
1
Screws
2
Wall mounting plate
3
Cable gland
Loop the connection cable through the cable entry on the housing
3
base
1)
Information:
The cable gland can be mounted in three positions each displaced by
90°. Simply exchange the cable gland against the blind plug in the
suitable thread opening.
Connect the wire ends as described under "Single/Double
4
chamber housing" according to the numbering
Connect the screen to the internal ground terminal, connect the
5
outer ground terminal above on the housing to potential equal-
isation
Tighten the compression nut of the cable entry. The seal ring must
6
completely encircle the cable
Attach the mounting plate again and tighten the screws
7
The electrical connection of the sensor to the external housing is
finished.
The connection cable is already preconfectioned. If necessary, shorten it to
1)
the requested length, cut the breather capillaries clean. Remove approx.
5 cm of the cable mantle, strip approx. 1 cm insulation from the ends of the
individual wires. After shortening the cable, fasten the type plate with sup-
port back onto the cable.
5 Connecting to power supply
3
19