D-Link DES-3250TG User Manual page 30

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
The switch's MAC address can also be found from the console
program under the Switch Information menu item.
Setting an IP Address
The IP address for the switch must be set before it can be
managed with the web-based manager. The switch IP address
may be automatically set using BOOTP or DHCP protocols, in
which case the actual address assigned to the switch must be
known.
The IP address may alternatively be set using the
Command Line Interface (CLI) over the console serial port
as follows:
1. Starting at the command line prompt local>, enter
the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x's
represent the IP address to be assigned to the IP
interface named System and the y's represent the
corresponding subnet mask.
2. Alternatively, you can enter the commands config
ipif System ipaddress xxx.xxx.xxx.xxx/z. Where
the x's represent the IP address to be assigned to
the IP interface
represents the corresponding number of subnets in
CIDR notation.
Using this method, the switch can be assigned an IP address
and subnet mask that can then be used to connect a
management station to the switch's Web-based management
agent.
named System and
22
the z