D-Link DES-3250TG User Manual page 105

Bridge Priority (0-
65535 Sec)
<32768>
STP Version
TX Hold Count(1-
10)
Forwarding BPDU
<Enabled>
Note: The Hello Time cannot be longer than the Max. Age.
Otherwise, a configuration error will occur.
Observe the following formulas when setting the above
parameters:
Max. Age ≤ 2 x (Forward Delay - 1 second)
Max. Age ≥ 2 x (Hello Time + 1 second)
DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
A Bridge Priority for the switch can
be set from 0 to 65535. This number
is used in the voting process between
switches on the
determine which switch will be the
root switch. A low number indicates
a high priority,
probability that this switch will be
elected as the root switch.
Choose rstp or StpCompatibility. Both
versions use STP parameters in the
same way. RSTP is fully compatible
with IEEE 802.1d STP and will
function with legacy equipment.
This is the maximum number of
Hello packets
interval. The count can be specified
from 1 to 10. The default value is 3.
This allows you to control whether or
not to forward Bridge Protocol Data
Units. Disabling this setting can be
useful if, for example, the present
switch has been designated as the
root bridge and you do not want that
status to change.
97
network to
and a high
transmitted per