Danfoss ECL Comfort 310 Operating Manual page 142

Operating Guide ECL Comfort 310, application A333
6.8.8 Sensor offset (new functionality as from firmware 1.59)
The measured temperature can be offset adjusted in order to
compensate for cable resistance or a not-optimum place for the
temperature sensor. The adjusted temperature can be seen in "Raw
input overview" and "Input overview".
Common controller > System > Sensor offset
Sensor 1 . . . (temperature sensor)
Circuit
Setting the offset of the measured temperature.
Positive The temperature value is increased
offset
value:
Negative The temperature value is decreased
offset
value:
6.8.9 Display
Backlight (display brightness)
Circuit
Adjust the brightness of the display.
0: Weak backlight.
10:
Strong backlight.
Contrast (display contrast)
Circuit
Adjust the contrast of the display.
0: Low contrast.
10:
High contrast.
6.8.10 Communication
Modbus addr.
Circuit
Set the Modbus address if the controller is part of a Modbus
network.
1 ... 247: Assign the Modbus address within the stated setting
range.
142 | © Danfoss | 2017.09
Setting range Factory setting
*
60058
Setting range Factory setting
0 ... 10
60059
Factory setting
Setting range
0 ... 10
38
Setting range Factory setting
1 ... 247
*
5
3
1
VI.GU.T2.02