Audio1, Audio2 Menus And Audio1 Gain, Audio2 Gain Menus; Alarm Menu; Trigger Field; Test Field - Motorola DSR-6050 Operator's Manual

3

Audio1, Audio2 Menus and Audio1 Gain, Audio2 Gain Menus

Alarm Menu

Trigger Field

Test Field

20
button to move into the field. Press the56buttons to display the options: OFF and
ON. The default is OFF. When the ON option is selected, the DSR-6050 supplies
20 VDC on the RF In Port 1 antenna input connector. See Figure 2-2 on page 2.
DSR-6050 supports AC3 passthrough audio. Support for analog audio will be
considered for a future release.
Press the6button until the Alarm menu is located. This menu allows the user to set
up different bypass modes in case the DSR-6050 goes into an alarm condition.
Press the4button until the cursor is at the Trigger label, and press the ENTER button
to move into the field. Press the56buttons to display the options The Trigger field
allows the user to select the trigger condition for which the alarm is activated. When
the alarm is activated the Alarm LED illuminates and the alarm relay indicates an
alarm condition. The alarm is activated for any of the following conditions:
• The tuner looses lock when the input is RF (Loss of the Signal LED).
• The DSR-6050 cannot lock to the ASI input when the specified input is ASI.
• The DSR-6050 is unable to render video.
• The DSR-6050 is not authorized to access the selected service.
There are five choices: Auto, No Signal, No Video, No Auth (Authorization), and
Disabled. Use this option to select which of the above conditions activates the
alarm. The default setting is Auto.
The Test field provides an alarm test. The alarm is activated when this field is set to
On. The Test field returns to the default value (Off) when the field is exited.