Wall Mounting - Endress+Hauser Liquicap M FTI51 Operating Instructions Manual

Liquicap M FTI51, FTI52
!
!
Endress+Hauser
B (mm)
H1 (mm)
Probes Ø10 mm rod
Probes Ø16 mm rod or
rope (without fully
insulated inactive
length)
Probes Ø 22 mm rod or
rope (with fully
insulated inactive
length)
Note!
Connecting cable: ø10.5 mm
Outer jacket: silicone, notch resistance
3.6.2 Wall holder unit
Note!
• The wall holder unit is part of the scope of supply.
• The wall holder unit has to be screwed to the separate housing before you can use it as a
drilling template. The distance between the holes is reduced by screwing it to the separate
housing.
3
3.6.3

Wall mounting

• Push the bracket onto the sleeve and screw it into place.
• Mark the distance between holes on the wall, then drill the holes.
• Screw the separate housing to the wall.
Polyester housing Stainless steel
(F16) housing (F15)
76 64
172 166
G 1/2", G 3/4", G 1", NPT 1/2", NPT 3/4",
NPT 1", Clamp 1", Clamp 1 1/2", Universal
Ø44, flange < DN 50, ANSI 2", 10K50
G11/2", NPT11/2", Clamp 2", DIN 11851,
flanges DN 50, ANSI 2", 10K50
86
70
Installation
Aluminum housing
(F17)
65
177
H4 (mm) D (mm)
66 38
66 38
89 50
89 38
TI418F20
17