SunStar SPS/A-3020 5030 SERIES User Manual page 23

e) Separate lower feed plate from main body.
As it is the state that cut off the influx of
air, separate lower feed plate after vertically
pushing up the cylinder knuckle④ of lower
feed plate.
B. Attachment of Pallet
a) Make the basic pallet provided in the
accessory box to comply with the shape of
working material.
b) Push in the pallet⑥ so that stopper⑤ can
be inserted into the "ㄷ"shaped groove in
the guiding plate⑦.
C. Preparations prior to Sewing Start
a) Turn on the power.
b) As soon as the power on, cylinder knuckle④ in Figure 28 falls and stopper⑤ is fixed.
(Ref. : If cylinder knuckle④ is not properly inserted into stopper⑤, adjust it to be inserted to the
right location by putting up/down by using "0"key on the operation panel.)
c) Insert the diskette containing the pattern to sew into floppy disk driver and call out the shape to
sew.
d) In pallet work, the pallet can strike the machine when opening the pallet after completion of sewing
work according to using method. In such case, set the 2nd original point and after completing
pattern work, move the pallet to one end of the left/right and then open the pallet. For setting
method of the 2nd original point, see the content in page 33.
e) Setting the 2nd original point ends and pressing "EXE"key on the operation panel, pallet transfers
to the 2nd original point and waits the work.
f) Stepping on the left footplate switch, pallet transfers to sewing start point and performs sewing work
immediately. When sewing work is completed, pallet transfers to the 2nd original point and the
machine stops.
[ Caution ]
At the moment of shipping, generally the machine is set to use Upper/Lower /Clamp Device. In case of
using pallet, you should change the setting from "1) DISABLE"to "2) ENABLE"in parameter number "013,
whether to maintain constant fall of upper feed plate" . After initialization of parameter, you must change
this setting to "2) ENABLE" . If parameter change is completed, you may perform the work by using the
left footplate switch only.
g) Completing the work, store the pattern data by pressing "WRITE"key before taking out the
diskette containing the pattern to sew from floppy disk driver. As the data of the 2nd original point
is stored as well, you don' t need to reset the 2nd original point when you call it out gain.
⑦
④
⑤
⑥
④
[ Fig. 27 ]
[ Fig. 28 ]
23