Motorola iM1000 User Manual page 55

iM1000 -Data Modem
Symptom
Received data is
unrecognizable.
Data is intermittently
lost.
The modem does not
respond to a hang-up
command from the
software's command
mode.
Slow modem response
than usual and/or drops
connections
occasionally.
Software reports
various modem
initialization errors when
it attempts fax calls.
Images transmitted/
received are of poor
quality
54
Table 3: Identifying Symptoms
Make sure that flow control is set to RTS/
CTS (that is, hardware flow control is
enabled) in the communication software
and set to &K3. See
Communications Software
Make sure that flow control is set to RTS/
CTS (that is, hardware flow control is
enabled) in the communication software
and set to &K3. See
Communications Software
Make sure that:
• Drop DTR on Hang-Up is enabled in the
communication software.
• The hang-up string setting is
Check the signal strength icon to be sure
the signal is not weak.
Make sure that:
• The modem is switched on.
• The cable is connected properly.
• The cable is connected to the correct
port and that this is the same port
specified for use in your communication
software.
• You subscribed to the Data feature with
your iDEN carrier.
• The baud setting on the modem matches
the baud setting in your software.
• A generic Class 2 fax/modem is selected
in the communication software.
• The computer port's baud rate is locked
at the recommended 19200 setting as
specified in the installation instructions.
• The RTS/CTS flow control is enabled in
the fax application and set to &K3.
Ensure that the RTS/CTS flow control is
enabled in the communication software
and set to &K3. See
Communications Software
Troubleshooting Tips
"
Configuring
"
"
Configuring
"
"
Configuring
"
on page 51.
on page 51.
" "
+++ATH .
on page 51.