Reading The Value Of An S-Register; Customizing S-Registers - Motorola iM1000 User Manual

Reading the Value of an S-Register

You may also want to read the value of a particular S-register.
For a list of supported S-registers, see Table 7 on page 91.
To read the value of an S-register:
1. Bring up the command mode of your communication software.
2. Type ATSn where n is the number of the S-register that you want to
read from the software's command mode.
For example, to read the value of S-register number 0 (zero), you
would type ATS0?.
3. Press Enter. The value of the requested S-register displays.
4. If you attempt to read the value of an S-register that is not supported,
the modem displays the message,
You can also read S-register values in bulk by issuing an AT&V command.

Customizing S-Registers

You can use the following list of S-registers to customize the modem's data
operation.
Register #
0
2
Table 7: Supported S-Registers
Automatic Answer. Determines if the modem
automatically answers an incoming call.
• If the value assigned to this register is 0 (zero), the
modem does not answer the call, but sends an
appropriate message to the computer that
commands the modem to answer the call.
• If the value assigned to this register is non-zero, the
modem answers the call without waiting for the
computer to issue its answer-call command.
The valid range of values is 0 (zero) to 255. The
default is 0 (zero).
Escape Code Character. Specifies the ASCII
character to be used to escape from either data or
online mode to command mode.
The valid range of values is 0 (zero) to 127. The
default is 43 or the ASCII plus (+) key.
.
ERROR
Function
APPENDIX
91