Remove the drive cage.
7.
Remove the drive backplane.
8.
To replace the component, reverse the removal procedure.
Replacing a drive in the non-hot-plug drive cage
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the bezel
3.
Remove the access panel
4.
Disconnect the cables from drive.
5.
("Unlock and remove the
("Removing the access
bezel" on page 26).
panel" on page 26).
Removal and replacement procedures 33