A-240Z-A Connections And Components - Nokia 7368 Product Manual

7368 ISAM CPE A-240Z-A Product Guide
5.4.1
Figure 7 A-240Z-A CPE physical connections
ON/OFF
button
Issue: 01

A-240Z-A connections and components

Figure 7 shows the physical connections for A-240Z-A CPEs.
ON/OFF TEL1 TEL2 WAN
TEL1 and TEL2
WAN port
POTS ports (RJ-45)
(RJ-11)
Table 6 describes the physical connections for A-240Z-A CPEs.
Table 6 A-240Z-A CPE physical connections
(1)
Connection
On/Off button
POTS ports
WAN port
Ethernet ports (LAN)
USB ports
UPS (power supply) input
LED ON/Off button
Reset button
Power input
Note
(1)
The primary path for the earth ground for these CPEs is provided by the 12V Return signal in the power
connector.
LAN1 LAN2 LAN3 LAN4
LAN ports (4)
(RJ-45)
Description
This button turns the CPE on or off.
This connection is provided through RJ-11 ports. Up to two POTS connections are
supported.The POTS ports support voice services.
This connection is provided through an RJ-45 GE interface.
This connection is provided through Ethernet RJ-45 connectors. Up to four
10/100/1000 Base-T Ethernet interfaces are supported.The Ethernet ports can
support both data and in-band video services on all four interfaces.
This connection is provided through 2 USB 2.0 ports. The maximum combined
current is 1000mA. The throughput for each port is 90 Mbps. The CPE supports
external USB hard drives that can be made accessible to all LAN devices.
This connection is provided through a UPS connector.
This button is used to turn all LEDs on or off.
Pressing the Reset button for less than 10 seconds reboots the CPE; pressing the
Reset button for 10 seconds resets the CPE to the factory defaults, except for the
LOID and SLID.
This connection is provided through the power connector. A power cable fitted with
a barrel connector is used to make the connection.
3FE-46615-AAAA-TCZZA
A-240Z-A unit data sheet
USB USB UPS LED
USB 2.0 LED on/off
Power supply
ports (2) connector
POWER
Power
connector
Reset
button
button
26018
41