Procedure; Figure 13 A-240Z-A Cpe Connections - Nokia 7368 Product Manual

7368 ISAM CPE A-240Z-A Product Guide

6.6 Procedure

Figure 13 A-240Z-A CPE connections
ON/OFF
button
Issue: 01
Use this procedure to install an A-240Z-A CPE.
1 Place the CPE unit on a flat surface, such as a desk or shelf.
Note —
other equipment. The CPE mounting requirements are:
•
allow a minimum 100 mm clearance above the top cover
•
allow a minimum 50 mm clearance from the side vents
•
do not place any heat source directly above the top cover or below the
bottom cover
2 Review the connection locations as shown in Figures 13.
ON/OFF TEL1 TEL2 WAN
TEL1 and TEL2
WAN port
POTS ports (RJ-45)
(RJ-11)
3 Connect the Ethernet cables to the RJ-45 ports; see Figure
ports.
4 Connect the WAN cable to the RJ-45 WAN port; see Figure
WAN port.
5 Route the POTS cables directly to the RJ-11 ports as per local practices.
The POTS port to the left is labeled TEL1 for Line 1 while the port on the right is labeled TEL2
for Line 2, as shown in Figure 13.
6 Connect the power cable to the power connector.
The A-240Z-A cannot be stacked with another CPE or with
LAN1 LAN2 LAN3 LAN4
LAN ports (4)
(RJ-45)
3FE-46615-AAAA-TCZZA
Install an A-240Z-A CPE
USB USB UPS LED
USB 2.0 LED on/off
Power supply
ports (2) connector
13 for the location of the RJ-45
13 for the location of the RJ-45
POWER
Power
connector
Reset
button
button
26018
51