Table 5-5 Beacon G6 Physical Connections; Figure 5-2 Beacon G6 Connections And Components - Nokia Beacon G6 Product Manual

Beacon G6 unit data sheet
Beacon G6 interfaces and interface
Figure 5-2
Table 5-5, " Beacon G6 physical connections" (p. 44)
Beacon G6 .
Table 5-5 Beacon G6 physical connections
Connection 1
Print Letters
Ethernet ports
LAN1 to LAN3
and WAN
Power input POWER
RESET
Reset button
See Figure 6-2,
"Beacon G6
reset button at
the bottom of the
device" (p. 55)
WLAN
WLAN button
WPS
WPS button
44
capacity
Beacon G6 connections and components
Description
This connection is provided through Ethernet RJ-45 connectors. The connections support the
following:
• LAN1 and LAN2 are 1000/100/10 Base-T
• LAN3 is 2.5G/1G/100M Base-T
• WAN is 2.5G/1G/100M Base-T
This connection is provided through the power connector. A power cable fitted with a barrel
connector is used to make the connection.
Pressing the Reset button for less than 10 seconds reboots the Beacon G6; pressing the
Reset button for 10 seconds resets the Beacon G6 to the factory defaults.
Wi-Fi service is compliant with IEEE 802.11 standards. If the WiFi signal is disabled, extender
Wi-Fi points that use wireless mesh backhauling will looses their backhaul connection and
goes into an error state until the W-Fi service on the Beacon G6 is restored.
The Wi-Fi Protected Setup (WPS) button enables and disables the WPS.
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA
WPS Wi-Fisecurity/
WLAN on/offbuttons
LAN1
1GbpsLAN
LAN2
1GbpsLAN
LAN3 2.5GbpsLAN
2.5GbpsWAN
WAN
ON/OFF
On/off
POWER
button Power
describes the physical connections for
Beacon G6
37374
June 2022
Issue 1