Configure An A-240Z-A Cpe; General; Gui Configuration; Login - Nokia 7368 Product Manual

7368 ISAM CPE A-240Z-A Product Guide

8 Configure an A-240Z-A CPE

8.1 General

8.2 GUI configuration

8.2.1
Procedure 6
Issue: 01
8.1 General
8.2 GUI configuration
8.3 IOT application software package download
Please refer to the configuration information provided with your OLT for the software
configuration procedure for an A-240Z-A CPE.
For HTTP configuration procedures, please refer to the 7368 ISAM CPE
Configuration, Management, and Troubleshooting Guide.
Use the procedures below to use the web-based GUI for the A-240Z-A.
The A-240Z-A is used as an Ethernet gateway to connect devices in the home to the
Internet. The GUI provides a variety of features for the home network including
routing and firewall capability. By using the GUI, users can connect all smart
equipment in their home, including personal computers, set-top boxes, mobile
phones, and other consumer electronics devices, to the Internet.

Login

Use the procedure below to login to the web-based GUI for the A-240Z-A.
Login to web-based GUI
1 Open a web browser and enter the IP address of the CPE in the address bar.
The login window appears.
The default gateway IP address is http://192.168.1.1. You can connect to this IP address
using your web browser after connecting your PC to one of Ethernet ports of the CPE. The
static IP address of your PC must be in the same 192.168.1.x subnet as the CPE.
2 Enter your username and password in the Log in window, as shown in Figure 15.
3FE-46615-AAAA-TCZZA
Configure an A-240Z-A CPE
57