Additional Tips; Sanitization; Disinfection Of Water Softeners - Pentair AUTOTROL 604 Installer Manual

A
Caution
Ensure that the system has been properly disinfected by the water conditioning system
manufacturer's recommendations.
The water conditioning system is now fully operational.
The display will show the hour of the day and the decimal point at the bottom centre of the display will
blink when water is flowing.

7.1.2. Additional tips

• The preset default time of regeneration is 2:00 AM.
• Power supply : The World controller senses the electrical input and decides which is needed.
• Make sure the control power source is plugged in. The transformer should be connected to a
non-switched power source.
7.2.

Sanitization

7.2.1. Disinfection of water softeners

The construction materials of the modern water conditioner will not support bacterial growth, nor will
these materials contaminate a water supply. During normal use, a conditioner may become fouled
with organic matter, or in some cases with bacteria from the water supply. This may result in an off-
taste or odour in the water.
Some softeners may need to be disinfected after installation and some softeners will require periodic
disinfection during their normal life.
Depending on the conditions of use, the conditioner type, the type of ion exchanger, and the
disinfectant available, a choice can be made among the following methods.
Ref. MKT-IM-007 / A - 16.12.2016
Installer Manual Autotrol 368 / 604-606 - Commissioning
33 / 54