Setting Parameters At The Device; Configuration Layers - Siemens 7MC3040-... Operating Manual

s
nection. When you have completed the function test, exit by pressing
ESC
" " and return to normal operating mode.
8

Setting Parameters at the device

In addition to the configuration possibilities described in Chapter 7, many
parameters can be adjusted at the rear panel using push buttons. These
settings can be accessed via configuration layers.
8.1

Configuration layers

The configuration layers are structured as follows:
 C001

C010
 C011

C020

C100
The following chart lists all parameters. Certain parameters will be sup-
pressed at the rear panel display if the prerequisite function is deactivat-
ed. For example: the smoothing time cannot be configured when signal
smoothing is not activated.
Temperature measurement via spectral channel 1 (configuration
C001
layer: )
Parameter Function
EPS.1
Emissivity factor L1
Transmission factor
TAU.1
L1
Ambient tempera-
BAC.1
ture compensation
Temperature of
BAC.T
ambient source of
radiation
Influence of ambient
BAC.%
IR radiation
Temperature offset
LIN.1
using linear interpo-
lation
L. X1
node x 1..10
L. Y1
node y 1..10
FIL.1
Smoothing filter
Temperature measurement via spectral channel 1
I/O Configuration
General functions
Display temperature readings
Simulated current signal for outputs Ao1 and Ao2
Operating manual PA
Explanation
See Chap. 7
See Chap. 7
See Chap. 7
The reflected thermal radiation from the sur-
roundings as a portion of the total IR radiation
collected by the sensor in %
OFF off
2-10: number of nodes used
Signal input (initial value) node n
Signal output (resulting value) node n
OFF smoothing not activated
33