Siemens 7MC3040-... Operating Manual page 45

s
General Functions (configuration layer:
Parameter Function
LED.G
Green status LED
PILO.
Activate laser*
PIL.T
Laser ON-time*
TERM.
Assign Interface
Automatic tempera-
A.STR.
ture data output
Cycle for automatic
temp. data output
A.CYC.
ADDR.
Device address
DISP.
Display panel**
UNIT
temperature scale
Screen insert tem-
C.OVL.
perature reading**
TBC exposure me-
C.TBC.
tering**
C.COL.
White balance**
SAVE
Save
ESC
Escape
* only available for models with laser sighting
** only available for models with camera
Displayed temperature readings (Configuration layer:
Parameter Function
Temp. reading
L1.
Lambda1
Reading Lambda1
L1.PR.
without peak picker
T.INT.
Inner temperature
Initial value at ana-
AIN
logue input
ESC
Escape
Operating manual PA
C011
)
Explanation
ON LED indicates 24V
DO1 LED indicates digital output 1
DO2 LED indicates digital output 2
LED indicates running measurement in
TAC1
mode for ADT function
INT keypress
OFF laser disabled
T.DI1 edge-triggered, switching input 1
T.DI2 edge-triggered, switching input 2
select auto laser shut-off in minutes
1-15:
OFF non-terminal mode
USB terminal mode at USB interface
R485 Terminal mode at RS485 (Halbduplex)
OFF automatic temp. data output is off.
ON temp. data output at PC terminal
Select cycle time in s
Enter address of device for non-terminal mode
the display panel indicates "on"
"ON"
IA1 indicate temperature of source Ao1
°( degrees Celsius
°F degrees Fahrenheit
On
ON
Off
OFF
spot weighted
"ON"
average
"OFF"
daylight
"DAYL."
automatic
"AUTO."
Save changes / exit menu
Discard changes / exit menu
Explanation
Shows current temperature reading for L1
Shows current temperature reading for L1 prior to
peak picker
Current inner temp. of device
Current value of analogue input when activated
Exit menu
37
C020
)