Siemens 7MC3040-... Operating Manual page 32

s
ference is higher than the plausibility threshold
ta will be „0" and the average value will remain unchanged.
TSP_
Plausibility (
TSP~
Plausibility (
When sampling is completed, the average temperature value or „0" will
be output. At the same time, an impulse is generated which can be used
for the digital outputs. Enter
to 0.5 s.
A cut-off interval (time lag) begins after the sampling time has ended
This cut-off interval must expire before the next measurement can start
with the cycle starting conditions described above.
Cut-off interval
T.DIS
( )
If a measuring cycle does not start during the period
average will be deleted and reinitialized when the next cycle begins.
T.OUT
Timeout (
Activate auto reset for the ATD function to run cyclically. Limit 1 will then
be ignored. Measurement continues when the Limit 2 is exceeded for the
period configured with
A.RST
Auto reset (
If, during the measurement, the temperature reading falls below Limit 2,
the measurement will be dismissed.
Set Li2 check on tAct (
** Only available with ATD function
) Threshold for plausiblity check: lower limit
which is acceptable for a valid measure-
ment.
) Threshold for plausiblity check: upper limit
which is acceptable for a valid measure-
ment.
M.TR.1
The interval between one completed sam-
pling and the start of a new sampling..
): Time cycle for deleting average value (in
minutes)
T.DEL
.
): Auto reset on/off
CH.L.2
)
24
Operating manual PA
TSP
, the transmitted da-
as the source and set the hold time
on/off
T.OUT
, the saved