Siemens 7MC3040-... Operating Manual page 54

s
Moreover, use a converter with galvanic isolation (e.g. W&T 38211) to
avoid problems with ground loops.
Caution !
If the supply voltage or current output are conducted via this ca-
ble, then make sure to consider the voltage drop if the cable
length is greater than 100 m.
 Disconnect the pyrometer from any voltage source
 Install all required electric connections
 Connect the converter with the PC
 Install the converter according to instructions.
 Connect the voltage supply for the pyrometer
 Change the parameter
 Start a terminal program such as Hyperterminal
 Select the correct COM port
 Set the correct parameters for the serial interface (see chapter
transmission of measurement values)
 Open the connection
. to
TERM R485
46
Operating manual PA