Advanced Settings - Multicast Paging; Table 31: Multicast Paging - Grandstream Networks GAC2500 Administration Manual

•
PSTN Disconnect Tone
Call-Waiting Tone Gain
Ring Cadence

Advanced Settings - Multicast Paging

This page will show only if Expert mode is enabled.
Paging Barge
Paging Priority Active
Multicast Paging Codec
Multicast Listening
Otherwise it will ring ON ms and a pause of OFF ms and then repeats
the pattern. Please refer to the document below to determine your local
call progress tones:
0203.pdf
By default, tones are set to the North American standard. Users could
adjust the tone frequencies based on parameters from the local telecom
provider. Users could select "Low", "Medium" or "High". The default
setting is "Low".
Defines the ring cadence for the phone. The default setting is:
c=2000/4000

Table 31: Multicast Paging

Sets the threshold of paging calls. If the paging call's priority is higher
than the threshold, the existing call will be hold and the paging call will be
answered. Otherwise, the existing call does not be affected. If it is set to
Disable, any paging call will not be answered. The default setting is
"Disable".
Determines if a new paging call whose priority is higher than the existing
paging call will be answered. If it is checked, this feature will be enabled.
The default setting is disabled.
Selects the codec type for the multicast paging call. This list includes
PCMU, PCMA, G726-32, G722, and G729A/B.
Priority Determines if a new paging call whose priority is higher than
the existing paging call will be answered. If it is checked, this
feature will be enabled. The default setting is disabled
Listening Configures the IP address and port number (valid port
Address range is 1- 65535) for monitoring multicast paging call.
When the initiator initiates a call, answer the call and display
listening address and tag of the monitoring target. This
feature supports Video Multicast, when the initiator initiates
Video Multicast, it will automatically add the number 2 on
the port of the listening address. Reboot the phone to make
changes take effect. The valid IP address ranges from
224.0.0.0 to 239.255.255.255. Users may also fill the label
for each listening address corresponding to the priority.
Defines the label for each listening address corresponding
Label
to the priority.
GAC2500 Administration Guide
http://www.itu.int/ITU-T/inr/forms/files/tones-
P a g e | 56