Table 22 Advanced - Multicast Paging Settings; Table 23 Advanced - Mpk General Settings; Table 24 Advanced - Mpk Lcd Settings - Grandstream Networks GAC2500 Administration Manual

Call Progress Tone
Ring Back Tone
Call-Waiting Tone Gain

Table 22 Advanced - Multicast Paging Settings

Paging Barge
Paging Priority Active
Multicast Paging Codec
Multicast Listening

Table 23 Advanced - MPK General Settings

BLF Call-pick Prefix
Event List URI
Force BLF Call-pickup by
Prefix

Table 24 Advanced - MPK LCD Settings

BLF List
Firmware Version 1.0.1.34
Users can configure call progress ring or tone frequencies based on
parameters from the local telecom provider. By default, they are set to
the North American standard. Please refer to the User Manual for
details.
The frequency must be accepted value to avoid uncomfortable high
tones. ON is ringing time (in ms) while OFF is mute time. In order to set
continuous ringing, the value of OFF must be 0, Otherwise it will ring
first. Pause OFFms after ONms then repeat the process. The biggest
value is three.
Users can configure ring or tone frequencies. The default setting is
c=2000/4000.
This configures the call-waiting tone gain. By default, they are set to the
North American standard. Users could adjust the tone frequencies
based on parameters from the local telecom provider. Users could
select "Low", "Medium" or "High". The default setting is "Low".
It is used to set the threshold of paging calls. If the paging call's priority
is higher than the threshold, the existing call will be hold and the paging
call will be answered. Otherwise, the existing call does not be affected.
If it is set to Disable, any paging call will not be answered. The default
setting is "Disable"
If enabled, when answering multicast page call, the phone will answer
the call with higher priority. The default setting is disabled.
Configures multicast paging codec.
It is used to listen multicast page. When the multicast page caller
initiates a call, answer the call to display listening address and tag of
the object. This feature supports Video Multicast, when the caller
initiates a call, it will add 2 on port address of the object address
automatically, reboot to make this setting take effect. The valid range is
224.0.0.0-239.255.255.255. Note: the port address should not be the
same as the ones the device already (e.g. SIP port, RTP port, WEB
access port), or it may cause no sound in an active call or no video.
Configures the prefix prepended to the BLF extension when the phone
picks up a call with BLF key. The default setting is ** for each account.
Configures the event list BLF URI on the phone to monitor the
extensions in the list with multi-purpose keys. The server side has to
support this feature. Users need configure an event list BLF URI on the
service side first (i.e., BLF1006@myserver.com) with a list of extension
included. On the phone, in this "event list BLF URI" field, fill in the URI
without the domain (i.e., BLF1006).
This is used to configure to always use the prefix for BLF Call-pickup.
The default setting is "No".
The configured MPK will show in the MPK List. Users could use
"Up" ,"Down" and "More" buttons to select, edit and delete the MPK.
Click the SAVE button to make changes take effect once changed the
BLF list order.
GAC2500 Administration Guide Page 32 of 54