Maintenance Page Definitions; Maintenance - Network Settings; Table 34: Maintenance - Network Settings - Grandstream Networks GAC2500 Administration Manual

Account
Name
User ID
Display Format
Show Display Name from
Server

Maintenance Page Definitions

Maintenance page lists Network Settings, Time & Language, Security Settings, Upgrade, troubleshooting
and MPK Settings.

Maintenance - Network Settings

Preferred Internet Protocol
Address Type
DHCP VLAN Override
Host name (Option 12)
Vendor Class ID (Option 60)
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
PPPoE Account ID
PPPoE Password
Selects the SIP Account used for the multi-purpose keys.
Configures the display name for the multi-purpose key.
Configures the User ID for the corresponding multi-purpose key mode.
Configures the display format for the multi-purpose keys. Users could
select display "Name", "UserID", or "UserID(Name)". The "Name" is the
name saved in GAC2500 Contacts. The default setting is "Name".
If check, the name on server will replace the one user configured before.
The default setting is "No".

Table 34: Maintenance - Network Settings

If IPv4 is selected, the phone will be using IPv4 addressing, otherwise, it
will be using IPv6 addressing. Default is Prefer IPv4
Allows users to configure the appropriate network settings on the phone.
Users could select "DHCP", "Static IP" or "PPPoE". By default, it is set to
"DHCP".
When set to "DHCP Option 132 and DHCP option 133", the phone will
get DHCP option 132 and 133 as VLAN ID and VLAN priority. When set
to "Encapsulated in DHCP Option 43", the phone will get values from
Option 43 which encapsulate VLAN ID and VLAN priority. Note: Please
make sure the "Allow DHCP Option 43 and Option 66 to Override Server"
setting under maintenance->upgrade is checked.
The default setting is "Encapsulated in DHCP Option 43".
Specifies the name of the client.
This field is optional but may be required by some Internet Service
Providers.
Used by clients and servers to exchange vendor class ID.
Enter the IP address when static IP is used.
Enter the Subnet Mask when static IP is used.
Enter the Default Gateway when static IP is used.
Enter the DNS Server 1 address when static IP is used.
Enter the DNS Server 2 address when static IP is used.
Enter the PPPoE account ID.
Enter the PPPoE Password.
GAC2500 Administration Guide
P a g e | 58