Multiple Table - Icom IC-FR5100 Series Handbook

Multiple table function
The IC-FR5100/FR6100 allows relaying between
multiple groups with one repeater. (When group
separation is carried out with a continuous tone)
This feature can be used in both analogue and digital
mode.
•Operation
−The C. Tone and/or RAN code is set for each group.
−When Group A is using the repeater, the other
groups cannot use it.
−When the Group A relay is finished, the other groups
can then use the repeater.
Repeater/Base station
Group A - Digital
RAN=11
Group B -
analogue
C.Tone=151.4Hz
Multiple table setup
Enter up to 16 C. Tone and/or RAN code in each Multi
Table.
• Table No.
Select the desired Multi Table No. within 1 to 16.
When the number is selected in Multi Table No. in
the Memory CH screen, the specified C. Tones and/or
RAN codes are used as the encoder and decoder in
the channel.
NOTE:
- When "analogue" is selected in CH Type in the
Memory CH screen, only the assigned C. Tones are
available.
- When "Digital" is selected in CH Type in the
Memory CH screen, only the assigned RAN codes
are available.
• Type
Select the signaling type from analogue and Digital.
Desired CTCSS frequency or
analog
DTCS code can be set in Decode
ue
and Encode (FM mode operation).
Desired RAN code can be set in
Digital
Decode and Encode (Digital mode
operation).
4-4

Multiple Table

Group B -
analogue
C.Tone=023N
• Decode/Encode
Enter the desired C. Tone and/or RAN code for
Decode and Encode columns respectively.
NOTE:
When "Simplex/Semi-Duplex" is selected in the
Operation Mode in the Memory CH screen, only
C. Tone and/or RAN code specified in Encode
columns are used.
When "analogue" is selected in Type
Select the desired CTCSS frequency from the list or
enter a 3-digit DTCS code with polarity, N (Normal) or
I (Inverse), for Decode and Encode respectively.
When "Digital" is selected in Type
Set the desired RAN (Radio Access Number) from 00
to 63 (decimal number) to separate the repeater from
the same/adjacent channel station according to the
assigned code for Decode and Encode respectively.
The repeater selectively accesses the one of several
repeaters within overlapping coverage areas allowing
the user to listen to a specific repeater.
"00" (decimal number) is a special code, and matches
to any RAN.
Memory Channel setup
• Operation Mode
Select the usage of the channel from Repeat, Full-
Duplex and Simplex.
For repeater operation.
Repeat :Repeat
For base station operation
Full-Duplex
in full-duplex mode.
:Full-Duplex
For base station operation
Simplex :Semi-
in simplex mode.
Duplex/Simplex
NOTE:
When "Repeat" or "Full-Duplex" is selected, enter
the different frequency in RX and TX columns.
Otherwise, the setting cannot be activated correctly.
• Multi Table No.
Select the desired Multi Table No. within 1 to 16 and
OFF.
Up to 16 C. Tones and/or RAN codes assigned in
the table can be decoded and encoded in the CH.
Multi Table setting in the Multiple Table screen must
be specified to use the function.
NOTE:
- When "analogue" is selected in CH Type, only the
assigned C. Tones in the selected Multi Table are
available.
- When "Digital" is selected in CH Type, only the
assigned RAN codes in the selected Multi Table are
available.
29