Icom IC-FR5100 Series Handbook page 31

3. Open the Properties window and select the
Settings sheet then click ASCII Setup to open
ASCII Setup window.
4. Select Echo typed characters locally by clicking
the checkbox.
• Close the windows by click "OK" buttons.
Remote Control Function
Operation
Receiving the PC command
When the Hyper terminal software starts, it is always
in receiving mode. With the PC and repeater
connected, turn the repeater power ON. The
following display appears.
[Memory ch=1], [Audible=off]
NOTE: For details, see the PC Command
Expansion (V2) specification sheet.
Start [STX] , V2 Command [*] , COMMAND, Stop [EXT]
Transmitting the PC command
Below is an example of reading the revision number
from the radio.
COMMAND=GET, INFO, REV
Enter STX(CTRL+B) * GET, INFO, REV
ETX(CTRL+C) from PC then STX * NTF, INFO,
REV, 2.0, $E73C EXT will be returned from
radio.
NOTE: Revision number and check sum differs
by each radio.
31