Table of Contents
Advertisement
HPOD
System Operation
2.1.8 C
ONNECTOR
The Output sample port connector is a type N female. It provides a nominal -40 dB
sample of the output signal. A calibration label is provided near the connector that shows
the actual coupling values vs. frequency.
2.2 T
URNING
The SSPA does not contain a 'Power On/Off' switch. The SSPA is powered ON by
connecting the J3 AC Power connector to the appropriate prime power source. The Mute
or Transmit status of the SSPA will automatically come up in the last stored state (factory
default = Transmit on, not muted).
WARNING
J9: O
S
UTPUT
AMPLE
O
SSPA
N THE
Never turn the unit ON without proper waveguide termination on the
J2 "RF OUTPUT" port. Individuals can be exposed to dangerously
high electromagnetic levels.
Figure 2-2. Outdoor Unit
2–6
Revision 2
Advertisement
Table of Contents
