HPOD
Maintenance
To install the fan assembly:
Step
Procedure
1
Visually inspect the exposed SSPA heat sink for any debris/blockage.
Clean as required
2
Connect the fan assembly's circular connectors to the SSPA
3
Place assembly on SSPA, ensuring proper alignment of the fasteners without any
cable /fan interference.
4
Tighten the six captive fasteners as indicated in Figure 5-2.
Note: Be certain to use an appropriate screwdriver, such as the one provided with the
SSPA, to avoid damaging the fasteners.
Figure 5-3. Fan Installation
5–4
Revision 2
MN/HPOD.IOM