Table of Contents
Advertisement
HPOD
Customer Commands
Command
(Instruction
Parameter Type
Code and
Qualifier)
Retrieve
N/A
Configuration
Status
Retrieve
N/A
Equipment Type
Retrieve
N/A
Firmware
Number
Arguments for
Description of arguments
Command or
(Note that all arguments are ASCII numeric
Response to
codes, that is, ASCII codes between 48 and 57)
Query
45 bytes,
Query only.
alpha-numeric
Used to Query the configuration status of the unit
Example: RCS='cr'
ATT=12.75'cr'
AMP=1'cr'
MUT=1'cr'
ONL=1'cr'
RED=1-1'cr'
GOF=00.00'cr'
AFR=1'cr''lf'
where:
ATT= attenuation in dB
AMP= RF power amplifier state, 0=OFF, 1=ON
MUT=RF mute state, 0=un-muted, 1=muted
ONL=Online status for redundancy
RED=Redundancy state and mode,
states: 0=OFF, 1=ON,
modes: 0 = auto, 1 = manual
GOF=Gain Offset in dB
AFR= auto fault recovery, 0=manual, 1=auto
22 bytes,
Query only.
alpha-numeric
The unit returns a string indicating the Model
Number and the version of the MnC firmware
installed in the unit.
Example: <1/RET?'cr'
>0001/RET=CPA-300 VER: 1.0.3'cr''lf'
Query only
Returns the firmware type loaded into the unit.
Note: the RET? Query returns the MnC firmware
revision.
Example: <1/FRW?'cr'
>0001/FRW='cr'
BULK=FW12524'cr'
MnC =FW12522'cr'
FPGA=FW10788'cr''lf'
Response to
Command
(Target to controller)
N/A
4–16
Revision 1
MN/HPOD.IOM
Query
(Instruction
Code and
qualifier)
N/A
RCS?
N/A
RET?
FRW?
Response to
query
(Target to
controller)
RCS=x....x
(see description
for details of
arguments)
RET=x....x
(see description
for details of
arguments)
FRW=x...x
(see description
for details of
arguments)
Advertisement
Table of Contents
