Programming Using A Paradox Memory Key - Paradox Spectra 1759EX V1.0 Reference & Installation Manual

3.3.2 C
ONFIGURING THE
The keypad's zone number and EOL definition are defined through the jumpers located on the PCB board. The
jumpers are as follows:
J1 - Keypad Zone Select Jumper
Jumper J1 determines whether the keypad's zone is Keypad Zone 1 or Keypad Zone 2. When the jumper is OFF, the
keypad's zone is Keypad Zone 2. When the jumper is ON, the keypad's zone is Keypad Zone 1.
J1 OFF - Keypad Zone 2
J1 ON - Keypad Zone 1
J2 - EOL Definition Jumper
Jumper J2 determines the keypad zone's EOL definition. When the jumper is OFF, EOL is disabled and the keypad zone
uses the on-board EOL resistor. When the jumper is ON, EOL is enabled and the keypad zone requires that an external
EOL resistor be connected (refer to Spectra 1759EX Control Panel Overview on page 7 and more details).
J2 OFF - EOL disabled
J2 ON - EOL enabled
3 . 4 P R O G R A M M I N G U S I N G A P A R A D O X M E M O R Y K E Y
Copy the sections of one Spectra control panel into the Paradox Memory Key (PMC-3). Then copy the contents of the Memory
Key into as many Spectra control panels as needed. Each panel is programmed in less than 3 seconds.
Download to DESTINATION Control Panel
1) Remove AC and battery power from the control panel.
2) Place the Memory Key on the serial connector labeled
to receive the contents of the Memory Key.
3) Reapply AC and battery power.
4) In installer programming mode, enter section [900], then press [
5) When the keypad emits a Confirmation Beep, remove the Memory Key.
6) Enter section [750] to reprogram the modules with the information downloaded from the
Paradox Memory Key.
Copy to Memory Key from SOURCE Control Panel
1) Remove AC and battery power from the control panel.
2) Place Memory Key on the serial connector labeled
want to copy. Make sure the write protect jumper of the Memory Key is on.
3) Reapply AC and battery power.
4) In installer programming mode, enter section [902], then press [
5) When the keypad emits a Confirmation Beep, remove the Memory Key. Remove the Memory
Key's jumper if you do not wish to accidentally overwrite its contents.
PLEASE NOTE: The keypad can be ordered with or without a tamper switch. If the keypad has no
tamper switch, key [3] will be OFF by default. If the keypad has a tamper switch, key [3] will be ON by
default.
1686H, 1686V
Figure 3.2: Paradox Memory Key
1689 K
AND EYPADS PRIOR TO
of the Spectra Control Panel that is
KEY
] to acknowledge.
ENTER
of the Spectra Control Panel that you
KEY
] to acknowledge.
ENTER
V2.0
P E C T R A
S
1 3
1 7 5 9 E X