Using The Quick Connect Feature - GE t60 Instruction Manual

1 GETTING STARTED
9. Enter the relay IP address specified in the
) in the "IP Address" field.
ADDRESS
10. Enter the relay slave address and Modbus port address values from the respective settings in the
UCT SETUP COMMUNICATIONS
11. Click the Read Order Code button to connect to the T60 device and upload the order code. If an communications error
occurs, ensure that the three EnerVista UR Setup values entered in the previous steps correspond to the relay setting
values.
12. Click OK when the relay order code has been received. The new device will be added to the Site List window (or
Online window) located in the top left corner of the main EnerVista UR Setup window.
The Site Device has now been configured for Ethernet communications. Proceed to the Connecting to the T60 section to
begin communications.
a) USING QUICK CONNECT VIA THE FRONT PANEL RS232 PORT
Before starting, verify that the serial cable is properly connected from the laptop computer to the front panel RS232 port
with a straight-through 9-pin to 9-pin RS232 cable.
1. Verify that the latest version of the EnerVista UR Setup software is installed (available from the GE EnerVista CD or
online from http://www.GEmultilin.com). See the Software Installation section for installation details.
2. Select the "UR" device from the EnerVista Launchpad to start EnerVista UR Setup.
3. Click the Quick Connect button to open the Quick Connect dialog box.
4. Select the Serial interface and the correct COM Port, then click Connect.
5. The EnerVista UR Setup software will create a site named "Quick Connect" with a corresponding device also named
"Quick Connect" and display them on the upper-left corner of the screen. Expand the sections to view data directly
from the T60 device.
Each time the EnerVista UR Setup software is initialized, click the Quick Connect button to establish direct communica-
tions to the T60. This ensures that configuration of the EnerVista UR Setup software matches the T60 model number.
b) USING QUICK CONNECT VIA THE REAR ETHERNET PORTS
To use the Quick Connect feature to access the T60 from a laptop through Ethernet, first assign an IP address to the relay
from the front panel keyboard.
1. Press the MENU key until the SETTINGS menu is displayed.
2. Navigate to the
SETTINGS
3. Enter an IP address of "1.1.1.1" and select the ENTER key to save the value.
4. In the same menu, select the
5. Enter a subnet IP address of "255.0.0.0" and press the ENTER key to save the value.
GE Multilin
SETTINGS
MODBUS PROTOCOL
PRODUCT SETUP COMMUNICATIONS
setting.
SUBNET IP MASK
T60 Transformer Protection System
1.3 ENERVISTA UR SETUP SOFTWARE
PRODUCT SETUP COMMUNICATIONS
menu.

1.3.4 USING THE QUICK CONNECT FEATURE

NETWORK IP ADDRESS
NETWORK IP
1
SETTINGS PROD-
setting.
1-9