Fujitsu IP-920 E/DC Hardware User's Manual page 71

How to connect wiring with IP-920E/DC connector (DC power cable)
In case of using HA216P-4S(72)
(1) Remove the insulation about 5-6 mm.
5～6mm
(2) Put the shell and the bushing together.
(3) Pass the cable through the hole.
(4) Solder the pin.
Pin #1 : (-)
Pin #2 : N.C
Pin #3 : N.C
Pin #4 : (+)
(5) Build it into the shell.
(6) Screw down the barrel.
(7) Screw down the clamp.
The bigger bore is
for IP-920 side
IP-920E/DC side
57
Chapter 4 Cable specifications
Cable side
Screw clamp (x 2)
IP-920E/DC