Air Supply And Exhaust Of The Equipment - Fujitsu IP-920 E/DC Hardware User's Manual

Chapter 2 Installation and Connection
b) The installation of IP-920E/DC in a rack should be such that the
c) The mounting of IP-920E/DC in a rack should be such that a hazardous
d) When using a bracket for mounting two products and you remove one
e) Confirm that power supplying capacity of power tap is larger than the
2.1.3

Air supply and exhaust of the equipment

IP-920E/DC is forced air cooled equipment. Be sure not to block the air intake/exhaust vents.
Provide an adequate amount of space around the vents.
IP-920E/DC
amount of airflow required for safe operation of IP-920E/DC is not
compromised.
IP-920E/DC has ventilation opening at the right and rear side.
-
- Do not cover or close these ventilation openings to prevent
overheating.
condition in not archived due to uneven mechanical loading. To keep
stability of the entire rack, please fix the rack to wall or floor by
suitable means.
- Be careful about injury during installation of IP-920E/DC into
rack.
Do not install IP-920E/DC into your rack where IP-920E/DC may
-
make the entire rack unstable.
- The weight of IP-920E/DC with the maximum configuration: 2.3
kg
product, do not leave the remaining one that is fixed at one end only
unattended. If you apply pressure to a product that is supported at
one end only, it may deform the mounting bracket.
total nominal power of all devices connected in the rack.
The nominal power of IP-920E/DC is DC +12-24V, 3.2–1.6 A.
30