Special Use Of Mnt Button - Fujitsu IP-920 E/DC Hardware User's Manual

Chapter 3 Operation Instructions
3.3
3.3
You can start IP-920E/DC by turning on the power while holding down the [MNT] Button (for
about 10 seconds) until the RDY LED begins blinking in orange. Doing so starts the IP-920E/DC
with the initial IP address and subnet mask with which the IP-920E/DC is shipped from the factory
(IP address 10.0.0.1, Subnet mask: 255.0.0.0).
Use this function when making initial settings for IP-920E/DC from a control terminal (such as a
PC having a LAN interface) (*1).
*1 When you operate the IP-920E/DC with the default IP address, connect this equipment to a
control terminal and make setting from the terminal with this equipment disconnected from
your network.
After making settings according to the requirements for your network, connect this
equipment to the network. If this equipment with the default settings made at the factory is
connected to the network, an unexpected problem may occur with your network.
If you start IP-920E/DC while holding the [MNT] button, set the IP addresses and subnet
masks of the control terminal to connect as follows:
- IP address
(xxx is any number from 0 to 255, excluding 10.0.0.0, 10.0.0.1, and 10.255.255.255.)
- Subnet mask
IP-920E/DC

Special Use of MNT Button

: 10.xxx.xxx.xxx
: 255.0.0.0
46