Cebora EVO SPEED STAR 380 TC Instruction Manual page 23

A
B
D
E
F
G
M
connected to the quick-fitting valves. NB Match the hose
and valve colors correctly. Only on machines with sepa-
rate wire feeder
L - Support:
Welding torch support.
M - Panel:
Cooling unit compartment cover.
N – Gas hose.
O - Gas hose fitting:
this is where the gas hose from the power source/trolley
connection is to be connected.
P- Connector:
this is where the service cable connector of the power
source/trolley connection is to be connected.
Q - Pressure switch socket:
it receives the cable from the pressure switch located in-
side the cooling unit (Art. 1683).
R – Fuse holder.
S – Socket:
it receives the cooling unit power cord Art. 1683 (optional).
T - ON/OFF switch.
N
L
Q
R
H
Fig. 10
U - Power cable.
V – Cylinder locking straps.
W – Cylinder support.
Z - Quick-fitting valves:
The red and blue hoses coming off the power source/trol-
ley connection must be connected to these quick-fitting
valves. Only on machines with separate wire feeder.
NOTE: The valves are located under the wire feeder trolley
.Match the hose and the valve colors correctly.
X – Socket:
In MIG/MAG welding, this is where the power source ca-
ble (+ pole) fast-on connector of the power source/trolley
connection is to be connected. Only on machines with
separate wire feeder.
Y - Fitting:
this is where the gas hose from the power source/wire
feeder extension connection is to be connected. Only on
machines with separate wire feeder.
K - Plug:
this is where the power cable fast-on connector of the
power source/wire feeder trolley connection is to be con-
nected. Only on machines with separate wire feeder.
AA - Wire reel cover door
V
S
T
U
V
W
23