3.3 EXTENSIONS CONNECTION
• Block one end of connection BA, by fixing the tip BB to
the bottom of the machine as shown in fig. 4.
• Connect all wiring on the back of the power source, as
• Avoid coiling the connection to reduce to a minimum
• Connect the other end of connection BA to the wire
Fig. 3
• The coolant fluid hoses must be connected to the
BA
BB
Fig. 4
shown in fig. 5.
Fig. 5
the inductive effects that could affect welding results.
feeder trolley as shown in fig. 6.
Fig. 6
quick-fitting valves located below the lower part of the
wire feeder trolley (see fig. 7), by matching the colours
appearing on the trolley front side.
Fig. 7
21