Welding Torch Connection; Assembly Of The Cooling Unit; Positioning; Sloping Planes - Cebora EVO SPEED STAR 380 TC Instruction Manual

3.4 WELDING TORCH CONNECTION.

• Connect the welding torch to the central adapter F.
• Mount the wire coil.
• Make sure that the groove of the rollers matches the
wire diameter used. To replace, proceed as follows
(Fig. 8):
BN
CA
Open the door of the wire feeder compartment
Remove the cover CA of the wire feeder unit.
Release the wire press rollers by means of the pressure
adjusting knob BN.
Replace the rollers and put the cover CA back in place.
Insert the wire into the feeder and into the welding
torch sheath.
Block the wire press rollers with the knob BN and ad-
just the pressure.
Connect the earth cable (provided) to the socket D.
Connect the gas hose to the fitting G.
3.5 ASSEMBLY OF THE COOLING UNIT (ART. 1683 -
OPTIONAL FOR ART. 318 AND 319) (Fig 9)
If a cooling unit is used, proceed as follows:
• Remove the panel M
• Insert the cooling unit inside the compartment so that
the fluid level inspecting slot can be seen from the front
of the unit.
• Fasten it to the welding machine trolley by means of
provided screws.
22
BN
Fig. 8
Fig. 9

3.6 POSITIONING

Position the welding machine to allow for a free air circu-
lation inside the machine and make sure to prevent intro-
duction of metal powders or any other dust.

3.6.1 Sloping planes.

Since this welding machine is equipped with wheels with-
out brake, do not position it on sloping planes, to prevent
machine tilting or uncontrolled movement.

3.7 START-UP

• Only skilled personnel should install the machine.
• All connections must be carried out in compliance with
current standards (IEC/CEI EN 60974-9) and in full ob-
servance of current safety laws.
• Mount the plug on the power cord, being especially
carefully to connect the yellow/green conductor to the
earth pole.
• Make sure that the supply voltage corresponds to the
rated voltage of the welding machine.
• Size the protective fuses based on the data listed on
the technical specifications plate.
4 POWER SOURCE DESCRIPTION (FIG. 10 = COM-
PACT VERSION) (FIG. 11 = VERSION WITH SEPARATE
WIRE FEEDER)
A - CONTROL PANEL.
Lift the transparent flap to access the control panel.
B- Connector:
DB9 type (RS 232) connector to be used for updating the
microprocessors programs.
C- Connector:
USB-type connector to be used for updating the micro-
processors programs. Only on machines with separate
wire feeder.
D- Connector:
Connector for connecting remote controls and the Push–
Pull torch control cable.
E – Socket (+):
Socket where you must connect the earth cable connec-
tor in Tig welding, the electrode clamp in MMA welding.
F - Central adapter:
this is where the welding torch is to be connected.
G – Socket:
Socket where you must connect the earth cable connec-
tor in MIG/MAG and MMA welding.
H - Fitting:
this is where the gas hose from the TIG torch is to be con-
nected.
I - Quick-fitting valves:
The hoses coming off the water cooled torch must be