Table of Contents
Advertisement
2.
In
Initiator object
relay or relay group. Activating and deactivating this object you activate specified action of action object ( ).
3.
In
Dependent object
to relay or relay group. Activating and deactivating this object you activate specified action of initiator object ( ).
4.
From the corresponding dropdown list select action that should be done when initiator activated ( ).
5.
From the corresponding dropdown list select action that should be done when initiator deactivated ( ).
6.
Click
Apply
in order to save changes ( ).
Setting up interlock is completed.
Sending commands to HoneyWell N-1000 controller
Sending commands to controller is carried out from setting panel of
basis of
N1000 panel
object on
Sending commands to controller is carried out the following way:
1.
Go to setting panel of
15
parameter group from
Type
parameter group from
Type
5
Hardware
tab of
System settings
N1000 command
object.
and
Name
dropdown lists select action object that corresponds to
and
Name
dropdown lists select action object that corresponds
N1000 command
dialog box.
1
3
4
object. This object is created on the
2
Hide quick links:
Advertisement
Table of Contents
