Creation And Setting Up Of Exit Groups - Honeywell N-1000 Settings Manual

Setting up exits is carried out the following way:
1. Go to setting panel of
2. Set address of exit in
3. In Impulse setting group set parameters of exit impulse:
a. In Duration
b. From the corresponding dropdown list select time zone during which power supply will be given to exit
automatically ( ).
4. If it's necessary set time zone during which there will be no interactions connected with this exit ( ).
5. Click Apply in order to save changes ( ).
Setting up exit is completed.

Creation and setting up of exit groups

Setting up exit groups is carried out on setting panel of
0 panel object on Hardware
Setting up exit groups is carried out the following way:
1. Go to setting panel of
11
N1000 exit object.
Exit address 1 ( ).
field set the period during which power supply (impulse) will be given to exit ( );
3
5
tab of System settings
N1000 group object.
N1000 group object. This object is created on the basis of
dialog box.
2
4
N100