Setting Up Honeywell N-1000 Access Point Readers - Honeywell N-1000 Settings Manual

2. In Door number
3. From Exit: dropdown list select
entrance ( ). 2
4. From Enter: dropdown list select
exit ( ). 3
5. Click Apply in order to save changes ( ).
Setting up access point parameters is completed.

Setting up HoneyWell N-1000 access point readers

Setting up access point readers is carried out on setting panel of
of N1000 door object on
Setting up access point readers is carried out the following way:
1. Go to setting panel of
9
set access point address ( ). 1
Region object that corresponds to the territory located on the side of reader's
Region object that corresponds to the territory located on the side of reader's
4
Hardware tab of System settings
N1000 reader object.
N1000 reader object. This object is created on the basis
dialog box.