Omron NX1P Programming Manual page 91

4.
Press the R Key to insert a rung below the first rung.
Insert N.O. Input power1_done and then insert the MC_Home motion FB.
Enter "Home1" as the instance name.
5.
Insert output home1_done (or any other name you prefer).
6.
Press the R Key to insert a rung below the second rung.
Insert N.O. Input home1_done and then insert the MC_MoveRelative motion FB.
Enter "Move1" as the instance name.
7.
Set the parameters as follows. (You do not need to set other parameters in this exercise.)
•
Distance : 1000 (pulses)
•
Velocity : 1000 (pulses/s)
These settings move the ball screw the set distance in a second.
Drag
Drag
91