Checking The Operation Of The Program - Omron NX1P Programming Manual

3.
Enter variables "data1" and "All_Data[n]" into the MOVE instruction.
4.
In the same way as the MOVE instruction, enter variable "n" into the Inc instruction.
4-2-9

Checking the Operation of the Program

This section explains how to check the operation of the program on the Simulator.
1.
Select Run from the Simulation Menu to start the Simulator.
2.
Select Watch Tab Page from the View Menu to display the Watch Tab Page (Table).
Drag All_Data in the variable table to the Watch Tab Page.
81