Prepared For Support Arm Or Stand Without Extension Elements (Flange On Top) - Siemens SIMATIC IPC477D Operating Instructions Manual

Mounting and connecting the device
3.3 Mounting the PRO device
3.3.2

Prepared for support arm or stand without extension elements (flange on top)

Requirements
● All packaging components and protective films have been removed.
● Siemens base adapter with screws (supplied with the device version "prepared for
support arm without extension elements (flange on top)" and "prepared for
stand/extension elements (flange on bottom)").
Note
Mounting without base adapter
If you install the device without a base adapter, you must adjust the mechanical interface
between the support arm or stand and the unit accordingly, including placement of an
appropriate seal on the mechanical interface of the device.
● Support arm or stand system from a third party (see section "System components for
PRO devices (Page 35)"), including, among other things, support arm or stand head (see
①
– Intermediate plate (see
– Coupling with screws without intermediate plate
● The following cables are fed through the stand or the support arm to which the device is
mounted:
– Protective conductor
– Power supply cable
– Data cables, e.g. USB
70
figure below) and a proprietary adapter set:
or
For even large connectors to fit, run their cables through the stand or support arm first,
for example, DVI or PROFIBUS.
②
figure below) with screws
Operating Instructions, 11/2016, A5E31347228-AF
SIMATIC IPC477D, IPC477D PRO