Removing A Pcie Card (Built-In Units With Pcie Card And Dvd Drive); Installing And Removing A Dvd Drive (Built-In Unit Only) - Siemens SIMATIC IPC477D Operating Instructions Manual

Expanding the device and assigning device parameters

6.4 Removing a PCIe card (built-in units with PCIe card and DVD drive)

6.4 Removing a PCIe card (built-in units with PCIe card and DVD drive)
The installation and removal of a PCIe card with devices that are expanded with a PCIe card
and with a DVD drive, is the same as the description in the section "Removing a PCIe card
(built-in units with PCIe card without DVD drive) (Page 140)". Access to the PCIe card slot is
covered by the DVD drive, as the following figure shows.
6.5

Installing and removing a DVD drive (built-in unit only)

The following section describes the installation and removal of a DVD drive for devices that
are expanded only with a DVD drive (not with a PCIe card).
Requirements
● The device is disconnected from the power supply.
● The device is removed.
● 1 T10 screwdriver
142
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 11/2016, A5E31347228-AF