Enabling Trunking - ZyXEL Communications ES-2724 User Manual

ES-2724 User's Guide
where
name <name>
mac <mac-addr>
vlan <vlan-id>
drop <src/dst/both>
An example is shown next.
• Create a filtering rule called "filter1".
• Drop packets coming from and going to MAC address 00:12:00:12:00:12 on VLAN.
sysname(config)# mac-filter name filter 1
sysname(config)# mac-filter name filter 1 mac 00:12:00:12:00:12 vlan 1 drop
both

41.8 Enabling Trunking

To create and enable a trunk, enter
press [ENTER]
Syntax:
trunk <T1|T2|T3|T4|T5|T6>
trunk <T1|T2|T3|T4|T5|T6> interface <port-list>
trunk <T1|T2|T3|T4|T5|T6> lacp
where
<T1|T2|T3|T4|T5|T6>
<T1|T2|T3|T4|T5|T6>
interface <port-list>
<T1|T2|T3|T4|T5|T6> lacp
An example is shown next.
284
= Names the filtering rule.
= Specifies the MAC address you want to filter.
= Specifies which VLAN this rule applies to.
= Selects the behavior of the rule.
trunk
.
= Enables the trunk.
= Places ports in the trunk.
= Enables LACP in the trunk.
• src - drop packets coming from the specified
MAC address
• dst- drop packets going to the specified MAC
address
• both - drop packets coming from or going to the
specified MAC address
followed by the ports which you want to group and
Chapter 41 Configuration Mode Commands