Chapter 46 Troubleshooting; Problems Starting Up The Switch; Problems Accessing The Switch; Table 97 Troubleshooting The Start-Up Of Your Switch - ZyXEL Communications ES-2724 User Manual

Intelligent layer 3
Hide thumbs Also See for ES-2724:
Table of Contents

Advertisement

This chapter covers potential problems and possible remedies.

46.1 Problems Starting Up the Switch

Table 97 Troubleshooting the Start-Up of Your Switch

PROBLEM
None of the LEDs
turn on when you
turn on the switch.

46.2 Problems Accessing the Switch

Table 98 Troubleshooting Accessing the Switch

PROBLEM
I cannot
access the
switch using
Telnet.
I cannot
access the
web
configurator.

Chapter 46 Troubleshooting

CORRECTIVE ACTION
Check the power connection and make sure the power source is turned on.
If the error persists, you may have a hardware problem. In this case, you should
contact your vendor.
CORRECTIVE ACTION
Make sure the ports are properly connected.
You may have exceeded the maximum number of concurrent Telnet sessions. Close
other Telnet session(s) or try connecting again later.
Check that you have enabled Telnet service access. If you have configured a secured
client IP address, your computer's IP address must match it. Refer to the chapter on
access control for details.
The administrator username is "admin". The default administrator password is "1234".
The username and password are case-sensitive. Make sure that you enter the correct
password and username using the proper casing. If you have changed the password
and have now forgotten it, you will need to upload the default configuration file. This
restores all of the factory defaults including the password.
If you have configured more than one IP interface, make sure another administrator is
NOT logged into the web configurator on a different IP interface using the same
account.
Check that you have enabled web service access. If you have configured a secured
client IP address, your computer's IP address must match it. Refer to the chapter on
access control for details.
Your computer's and the switch's IP addresses must be on the same subnet.
See the following section to check that pop-up windows, JavaScripts and Java
permissions are allowed.
C
H A P T E R
Troubleshooting
ES-2724 User's Guide
4 6
309

Advertisement

Table of Contents
loading

Table of Contents