Ftp Command Line Procedure; Gui-Based Ftp Clients; Ftp Restrictions - ZyXEL Communications ES-2724 User Manual

ES-2724 User's Guide

29.8.2 FTP Command Line Procedure

1 Launch the FTP client on your computer.
2 Enter
open
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter
bin
6 Use
put
firmware.bin ras
switch and renames it to "ras". Similarly,
configuration file on your computer (config.cfg) to the switch and renames it to "config".
Likewise
your computer and renames it to "config.cfg". See
information on filename conventions.
7 Enter
quit

29.8.3 GUI-based FTP Clients

The following table describes some of the commands that you may see in GUI-based FTP
clients.
General Commands for GUI-based FTP Clients
COMMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory Specify the default remote directory (path).
Initial Local Directory

29.8.4 FTP Restrictions

FTP will not work when:
• FTP service is disabled in the Service Access Control screen.
• The IP address(es) in the Remote Management screen does not match the client IP
address. If it does not match, the switch will disconnect the Telnet session immediately.
194
, followed by a space and the IP address of your switch.
to set transfer mode to binary.
to transfer files from the computer to the switch, for example,
transfers the firmware on your computer (firmware.bin) to the
get config config.cfg
to exit the ftp prompt.
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the server
for anonymous access. Anonymous logins will work only if your ISP or service
administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Configuration and firmware files should be transferred in binary mode.
Specify the default local directory (path).
put config.cfg config
transfers the configuration file on the switch to
Table 68 on page 193
put
transfers the
for more
Chapter 29 Maintenance