Ablerex ARES RT-1K User Manual page 15

X
* Press the Enter key to save changes.
4.3.3.10 Turn Off the Utility Input breaker.
4.3.3.11 Your setting changes are now complete.
4.3.3.12 Turn UPS off
(1) Line mode(AC input available) : Press Off key
beeps heard, UPS output will shut off. UPS will stay in standby mode,
fan(s) keep spinning and battery will be remained recharging if AC input
still available after output is off, otherwise it will be shutdown completely.
(2) Backup mode (AC input not available): Press Off key
until twice beeps heard, UPS output will shut off. 10 seconds later, fan
stop spinning and UPS shutdown completely.
4.3.3.13 Self-Test (Line mode only)
Self-test function can be applied when UPS is working under line
mode(AC input available). Press select key
beeps heard, backup mode LED indicator
approx 10 seconds and means the UPS is testing backup by battery,
and then switch back to line mode normal operation. If there was any
failure or battery condition found, LED indicator
and may companied with error code.
and hold until twice
and hold
and hold until twice
will be lit and last for
and will be lit
28
4.3.4 Beep Codes
The following table contains common UPS statuses with their beep codes.
UPS Status
UPS faulty, Inverter shut down.
All functions inhibited.
Control keypad error
UPS faulty, loads continue to
be supplied via Inverter or
Bypass.
In battery mode
Battery low
Confirm RS-232 port receiving
Service mode okay
Beep Code
Long Continuous Beep
Long Continuous Beep
Single beep every two seconds
Single beep once per second
Quick and short successive beeps
two quick and short beeps
one quick and short beep
29