Remove the redundant fan, if applicable.
5.
Remove the FBDIMM.
6.
To replace the component, reverse the removal procedure.
Parallel and second serial connector
To remove the component:
Power down the server (on page 26).
1.
Do one of the following:
2.
Unlock and remove the bezel
•
Extend the server from the rack (on page 26).
•
Remove the access panel
3.
Push the release latches on the expansion board retainer and open the retainer.
4.
("Front
bezel" on page 27).
("Access
panel" on page 29).
Removal and replacement procedures 48