Figure 45: Smoke Alarm To Base Alignment - AT&T Digital Life Installation And Operation Manual

Follow these steps to mount the smoke detector:
Step Action
1. Using the two screws and anchors provided, mount the base, as shown in
Figure 45.
2. Attach the unit to the base as follows:
Line up the raised alignment tab on the lip of the unit with the alignment
arrow on the base.
Insert the unit into the base and turn clockwise approximately 15
degrees. It should snap firmly into place.
IMPORTANT!
installed.
Installation and Operations Manual
The unit cannot be attached to the base if no batteries are

Figure 45: Smoke Alarm to Base Alignment

AT&T Proprietary (Internal Use Only)
—71—