AT&T Digital Life Installation And Operation Manual page 54

STEP 3. Install HPAV to Ethernet Bridge.
Action
Locate the customer's
Broadband Home Router (BHR)
and plug the HPAV to Ethernet
Bridge into an AC power outlet.
NOTE: Both the Power and PLC
Link LEDs should illuminate on
the HPAV to Ethernet Bridge
Device with the Power LED solid
green and the PLC Link LED
blinking green.
Installation and Operations Manual
Illustration(s)
The Functionality for each LED is described below:
Power LED
PLC Link
LED
Ethernet
LED
AT&T Proprietary (Internal Use Only)
—36—
SOLID – Device is receiving electrical
power
Blinking – Device is restarting or setting up
security
OFF – Device is not receiving electrical
power
SOLID – HPAV network is established with
other devices in the same network
Blinking – Data traffic exists over the HPAV
network
OFF – Device has not found any
compatible HPAV device using the same
encryption key
SOLID – Ethernet port is linked, but no
data traffic exists
Blinking – Ethernet port is linked and data
traffic exists over the Ethernet port
OFF – No Ethernet connection exists